Introduction

If your camcorder LCD screen is scratched, cracked or defective in any way, it will have to be replaced. This guide requires some tools and time.

Locate battery compartment cover. Turn the device over and locate the battery compartment cover. Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.
  • Locate battery compartment cover. Turn the device over and locate the battery compartment cover.

  • Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.

Add Comment

Locate the grey latch and move it aside. The battery is spring loaded and will pop up. Remove the battery.
  • Locate the grey latch and move it aside. The battery is spring loaded and will pop up.

  • Remove the battery.

Add Comment

Using the Phillips #000, remove the two screws on the LCD panel. Using the Phillips #000, remove two more screws near the LCD panel swivel point.
  • Using the Phillips #000, remove the two screws on the LCD panel.

  • Using the Phillips #000, remove two more screws near the LCD panel swivel point.

Add Comment

Use the plastic opening tool to remove the plastic cover from the LCD panel. Use the plastic opening tool to remove the plastic cover from the LCD panel.
  • Use the plastic opening tool to remove the plastic cover from the LCD panel.

Add Comment

Locate and remove two screws on the logic board. Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.
  • Locate and remove two screws on the logic board.

  • Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.

Add Comment

Locate the LCD screen underneath the logic board and slide it out. Locate the LCD screen underneath the logic board and slide it out.
  • Locate the LCD screen underneath the logic board and slide it out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Emanuel Keller

Member since: 02/28/2017

401 Reputation

4 Guides authored

Team

USF Tampa, Team S1-G4, Nance Spring 2017 Member of USF Tampa, Team S1-G4, Nance Spring 2017

USFT-NANCE-S17S1G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 46