Introduction

Use this guide to replace the LCD. The LCD tends to fade after about five years.

Image 1/1:
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Add Comment

Image 1/1: Pry up the panel; starting from the front/bottom corner, as indicated.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Add Comment

Image 1/1: Use tweezers to lift the panel.
  • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

  • Use tweezers to lift the panel.

Add Comment

Image 1/1:
  • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

Add Comment

Image 1/1: Use the Phillips Screwdriver to remove the four screws (in the red dots).
  • Use the tweezers to gently remove the straps (in the teal box).

  • Use the Phillips Screwdriver to remove the four screws (in the red dots).

  • Use your fingers to remove the silver plate.

Add Comment

Image 1/1: Once one end is lose, use the tweezers to lift the screen.
  • Use the Spudger on the edges of the screen.

  • Once one end is lose, use the tweezers to lift the screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Daniel Bussone

Member since: 01/28/2011

1,176 Reputation

11 Guides authored

Team

Cal Poly, Team 3-41, Regan Winter 2011 Member of Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 Members

11 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 19

All Time: 6,489