Introduction

This guide details how to replace the flash bulb of this camera.

  1. Locate the battery cover at the bottom of the camera.
    • Locate the battery cover at the bottom of the camera.

    • Pull down on the black tab to open the cover.

    Add Comment

  2. Push the grey tab on the right side of the battery.
    • Push the grey tab on the right side of the battery.

    • Remove the battery from the slot.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Using the Phillips screwdriver, unscrew the two 4.9mm Phillips head screws which are located underneath the flash.

    Add Comment

    • Remove the covering.

    Add Comment

    • Use the tweezers to remove the excess glue around the wiring. This will allow you to cut the wire and remove the light in the next step.

    Add Comment

    • Use the wire cutters to cut the wiring connected to the flash.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

Jordan Rabold

Member since: 04/14/2014

658 Reputation

3 Guides authored

Team

Cal Poly, Team 12-33, Maness Spring 2014 Member of Cal Poly, Team 12-33, Maness Spring 2014

CPSU-MANESS-S14S12G33

4 Members

7 Guides authored

3 Comments

how do you reverse step 6 - cutting the wires?

jeremyyoung - Reply

You dont tell how to make sure capacitors are discharged before changing the flash ? and do you know what is the replacement number of the flash bulb itself ?

jackqc09 - Reply

No parts required? So I can repair my flash not having to buy a new bulb? haha Please, I need the link from where I repair my burned built-in flash :/

gustavoaleme - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 26

All Time: 2,829