Introduction

This guide will show you how to access, remove, and replace the LCD screen. The process is safe and uncomplicated.

Image 1/1:
  • Remove two 4.8 mm black screws on the front of the camera.

Add Comment

Image 1/1:
  • Remove one 4.3 mm black screw under the lens ring and one 4.8 mm black screw on the bottom of the camera.

Add Comment

Image 1/1:
  • Remove one 4.8 mm black screw on the left side.

Add Comment

Image 1/1:
  • Remove the front panel by lifting out the side opposite the grip.

Add Comment

Image 1/1:
  • Remove outer eyepiece by sliding it upwards.

Add Comment

Image 1/1:
  • Remove two 4.75 mm screws from top of camera.

Add Comment

Image 1/1:
  • Remove four 4.3 mm screws from back of camera.

Add Comment

Image 1/1: Be careful, as top panel is still attached by wiring and ribbon cable to the camera.
  • Slowly separate top panel from camera by pushing up.

  • Be careful, as top panel is still attached by wiring and ribbon cable to the camera.

Add Comment

Image 1/1:
  • Separating the top panel too far can damage the connecting wiring.

Add Comment

Image 1/1: The gold connector can fall into the camera, but it will remain attached and can be pulled back up.
  • To unclip gold connector push the edge up and away from the lcd screen. A plastic opening tool is recommended.

  • The gold connector can fall into the camera, but it will remain attached and can be pulled back up.

Add Comment

Image 1/1:
  • Lift LCD screen out of mount.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Sterling Vinson

Member since: 04/17/2011

216 Reputation

5 Guides authored

Team

Cal Poly, Team 8-8, Regan Spring 2011 Member of Cal Poly, Team 8-8, Regan Spring 2011

CPSU-REGAN-S11S8G8

5 Members

11 Guides authored

One Comment

Thank's , your tutorial nice ... gracias

fajar - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 15

All Time: 4,338