Introduction
When removing the on/off switch of the compressor, you will first need to remove the shroud. The trick to removing the on/off switch is on the underside of the shroud. This is discussed in the guide.
-
-
Gently pull the wire attached from the pressure switch to the on/off switch.
-
It should come off the pressure switch with ease.
-
-
-
Gently pull the wire connected from the on/off switch to the motor of the compressor.
-
-
-
Twist the On/Off switch from the underside of the shroud.
-
Twist 90 degrees in any direction or until the on/off switch prongs are in a vertical position.
-
-
-
Push the on/off switch from the underside of the shroud until it comes loose.
-