Introduction

This guide will walk you through the process of replacing the faceplate on a Brother PT-D200.

Parts

No parts required.

Image 1/1:
  • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

Add Comment

Image 1/1:
  • Remove the six AAA batteries.

Add Comment

Image 1/1:
  • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

Add Comment

Image 1/1: Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.
  • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

  • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

Add Comment

Image 1/1: The ribbon cable is very fragile.
  • Gently pull out the ribbon cable from the circuit board.

  • The ribbon cable is very fragile.

Add Comment

Image 1/1: Gently pull the two-pin connector from the circuit board to avoid damaging the board.
  • Remove two-pin plastic connector from the circuit board.

  • Gently pull the two-pin connector from the circuit board to avoid damaging the board.

Add Comment

Image 1/1:
  • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

Add Comment

Image 1/2: Image 2/2:
  • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Christina Sardo

Member since: 01/24/2014

301 Reputation

3 Guides authored

Team

Cal Poly, Team 13-16, Regan Winter 2014 Member of Cal Poly, Team 13-16, Regan Winter 2014

CPSU-REGAN-W14S13G16

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 6

All Time: 313