Image 1/2: Image 2/2:
  • Remove the back cover of the phone

Add Comment

Image 1/1:
  • Remove the battery

Add Comment

Image 1/1: If you remove the screw in red, you void the warranty!
  • Unscrew the four screws using the T6 screw driver

  • If you remove the screw in red, you void the warranty!

Add Comment

Image 1/2: This is difficult to remove, but it should come off if you do it with caution. Image 2/2: This is difficult to remove, but it should come off if you do it with caution.
  • Remove front silver trim by using plastic opening tools and wiggle it off.

  • This is difficult to remove, but it should come off if you do it with caution.

Add Comment

Image 1/1:
  • Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Use the plastic removal tool to remove the entire back cover.

Add Comment

Image 1/1:
  • Unplug the black antenna wire from the logic board.

Add Comment

Image 1/2: They are orange and located on each side as well as on the top of the logic board Image 2/2: The cable circled in yellow is glued to the silver cap. Pull the ribbon cable upward towards the battery area.
  • Peel off the three ribbon cables

    • They are orange and located on each side as well as on the top of the logic board

    • The cable circled in yellow is glued to the silver cap. Pull the ribbon cable upward towards the battery area.

Add Comment

Image 1/1:
  • Take out your logic board

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Jocelyn Adorno

Member since: 10/16/2014

242 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 37

All Time: 2,264