Introduction

The motor within the black and decker dustbuster could fail. If that happens this guide will show you how to take the housing apart and extract the motor from the device. After extracting the motor from the device the replacement motor must then be inserted into the device and then the device closed back together. If the device doesn't work after this simply take the motor and insert the prongs on the opposite sides that they are inserted into on the circuit board.

To remove the filter and housing, press the green button labeled "Filter".
  • To remove the filter and housing, press the green button labeled "Filter".

Add Comment

Unscrew and remove all 5 screws using the Phillips 0 screw bit. Each screw is 17.5 mm long.
  • Unscrew and remove all 5 screws using the Phillips 0 screw bit. Each screw is 17.5 mm long.

Add Comment

  • Pull the housing apart

  • When you pull apart the housing pieces could fall out. Be sure to keep track of them.

  • Remove the motor unit from the housing

  • Note that the black disk needs to be firmly pulled it will resist, but can be pulled directly off of the pin if it is pulled hard enough.

Add Comment

  • Remove the motor from the circuit board.

  • The motor makes contact with the board at 2 points. These may be bent or distorted. Straighten them with a pair of needle nose pliers in order to remove.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ivette Muzquiz

Member since: 11/06/2017

301 Reputation

3 Guides authored

Team

IUPUI, Team S1-G4, Harley Fall 2017 Member of IUPUI, Team S1-G4, Harley Fall 2017

IUPUI-HARLEY-F17S1G4

3 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 3

Past 30 Days: 22

All Time: 159