Fix Your Stuff Community Store

Black and Decker DustBuster 15.6V Nozzle Brush Replacement

Introduction

The nozzle brush located on the end of shaft may break off during the cleaning process. Replacing the brush is as easy as breaking it off.

What you need

  1. Black and Decker DustBuster 15.6V Nozzle Brush Replacement, Nozzle Brush: step 1, image 1 of 1

    • Lift Nozzle Brush until it clicks into fully erect position.

    Edit

  2. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: step 2, image 1 of 1

    • Apply a gentle, equal pressure outward, to the inside of both brush legs.

    Edit

  4. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: step 3, image 1 of 1

    • Remove one of the leg prongs from the hole it is inserted into.

    Edit

  5. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: step 4, image 1 of 1

    • Rotate the free leg forwards or backwards from the hole.

    • This relieves the pressure from the inside of the legs allowing you to freely remove the last leg from its hole.

    Edit

  6. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: step 5, image 1 of 1

    • Check each leg hole for debris and clear whats needed.

    • Insert a leg of the new brush into the correct hole, so the brush will click into its erect position.

    • Slide the other leg into its respective hole.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 1 other contributor

Jacob

Member since: 03/15/17

101 Reputation

1 Guide authored

Badges: 2

Team

UMass Dartmouth, Team S6-G1, Isaacson Spring 2017 Member of UMass Dartmouth, Team S6-G1, Isaacson Spring 2017

UMASSD-ISAACSON-S17S6G1

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 4

Past 30 Days: 15

All Time: 324