Introduction

These are the first steps to taking apart the device.

Remove the five 30mm Phillips #0 screws on the bottom of the camera. Remove the five 30mm Phillips #0 screws on the bottom of the camera.
  • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

Add Comment

Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
  • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

  • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

Add Comment

It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.
  • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jerry Hadjah

Member since: 03/04/2016

525 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 66