Introduction

The battery can go bad on many devices. This guide includes removing the back plate and then detaching the battery from the rest of the watch.

Wedge a plastic opening tool between band contacts.
  • Wedge a plastic opening tool between band contacts.

Add Comment

Push in plastic opening tool until the components click and pop out of the holder.
  • Push in plastic opening tool until the components click and pop out of the holder.

  • Repeat steps for other band.

Add Comment

Remove four 4mm screws using a PH000 screwdriver.
  • Remove four 4mm screws using a PH000 screwdriver.

  • Remove back plate.

Add Comment

Use tweezers to remove elastomeric, or zebra, connector.
  • Use tweezers to remove elastomeric, or zebra, connector.

Add Comment

Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken. Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.
  • Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.

Add Comment

Use the pointy edge of the spudger tool to  detach battery leads from the circuit board.
  • Use the pointy edge of the spudger tool to detach battery leads from the circuit board.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Kaitlyn Lee

Member since: 11/06/2017

518 Reputation

4 Guides authored

Team

IUPUI, Team S6-G1, Baechle Fall 2017 Member of IUPUI, Team S6-G1, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G1

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 46