Introduction
In this prerequisite guide, we will remove the 4 screws on the bottom of the base. Then we will remove the gray cover from the base.
What you need
-
-
Take out the three 15 mm Phillips #1 screws.
-
Remove the 15mm T10 screw.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 15-1, Remmell Spring 2016 Member of USF Tampa, Team 15-1, Remmell Spring 2016
USFT-REMMELL-S16S15G1
3 Members
5 Guides authored
