Introduction

Prerequisite for removing the back panel of a Nikon Coolpix S3500.

  1. With the battery door facing upward, take your PH000 screwdriver and remove the 4 mm screws from the bottom of the device.
    • With the battery door facing upward, take your PH000 screwdriver and remove the 4 mm screws from the bottom of the device.

    Add Comment

  2. After removing the screws, rotate the device to where the micro USB port is facing up.
    • After removing the screws, rotate the device to where the micro USB port is facing up.

    • Now, take your PH000 screwdriver and remove the two 4 mm screws from the device.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Rotate the device 180 degrees so that the opposite side of the device is now facing upwards.

    • Now, take your PH000 screwdriver and remove the two 4 mm screws from the device.

    Add Comment

    • After all of the screws are removed, rotate the device so that the bottom of the device is now facing upward.

    • With your index finger, press down and slide open the memory card/battery door.

    Add Comment

    • Now take the plastic opening tool, and place it in the seam of the device.

    • Now, work the tool around the seam of the device until you can safely pry open the device.

    Add Comment

    • Be careful when removing the back piece of your device.

    • Using your free hand, finish prying off the back piece of the device.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Jordan Rosemeyer

Member since: 10/13/2015

455 Reputation

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 348