Introduction

If you need to replace any of the internal components of your laptop, you will first have to remove the HDD/RAM cover panel to gain access. This guide will show you the necessary steps needed to accomplish this.

Parts

No parts required.

Use a Phillips #000 screwdriver to remove the two 9mm screws from the HDD/RAM cover panel. Use a Phillips #000 screwdriver to remove the two 9mm screws from the HDD/RAM cover panel.
  • Use a Phillips #000 screwdriver to remove the two 9mm screws from the HDD/RAM cover panel.

Add Comment

Slide the back panel off by placing a hand on each corner and pulling the panel towards you. Slide the back panel off by placing a hand on each corner and pulling the panel towards you.
  • Slide the back panel off by placing a hand on each corner and pulling the panel towards you.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mark DeSimone

Member since: 10/19/2017

801 Reputation

8 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 2

All Time: 43