Introduction

This guide will walk through the steps to replace the RAM in your device. It does not involve any major disassembly and only requires a screwdriver and plastic opening tool.

Image 1/1: Be sure to unplug the netbook and power off the device while working.
  • Flip the netbook over.

  • Be sure to unplug the netbook and power off the device while working.

Add Comment

Image 1/1: The tab on the left will click open and stay in place until you close it.
  • Push open both tabs on either side of the battery.

  • The tab on the left will click open and stay in place until you close it.

Add Comment

Image 1/1: Pull the battery straight out ensuring that you don't damage any connectors.
  • Pull the tab on the right open, while you remove battery with your other hand.

  • Pull the battery straight out ensuring that you don't damage any connectors.

Add Comment

Image 1/2: Then use the plastic opening tool to open the RAM door. Image 2/2: Then use the plastic opening tool to open the RAM door.
  • Remove the two 4.6mm screws using the J0 Phillips head screwdriver.

  • Then use the plastic opening tool to open the RAM door.

Add Comment

Image 1/1: Only push the tabs over slightly to ensure you do not break them.
  • Push the tabs on the side of the RAM to release.

  • Only push the tabs over slightly to ensure you do not break them.

Add Comment

Image 1/1:
  • Remove the RAM by pulling it towards you.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Trae Mikesell

Member since: 10/04/2016

334 Reputation

3 Guides authored

Team

USF Tampa, Team 2-3, Nance Fall 2016 Member of USF Tampa, Team 2-3, Nance Fall 2016

USFT-NANCE-F16S2G3

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 86