Introduction

In order to replace or fix many parts on the Astak Mole, the mother board must be accessed. This task requires full disassembly of the bottom section of the Mole. This is very easy to accomplish.

Parts

No parts required.

Remove the four bottom tabs in order to access the bottom screws.
  • Remove the four bottom tabs in order to access the bottom screws.

Add Comment

Remove all four 14 mm Phillips #1 screws.
  • Remove all four 14 mm Phillips #1 screws.

Add Comment

Remove the SD card.
  • Remove the SD card.

Add Comment

Pry up the motherboard on the four points using a spudger.
  • Pry up the motherboard on the four points using a spudger.

  • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Add Comment

Gently pull back the motherboard to expose many of the component's wired connections.
  • Gently pull back the motherboard to expose many of the component's wired connections.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joseph Bello

Member since: 09/20/2016

228 Reputation

2 Guides authored

Team

USF Tampa, Team 2-2, Blackwell Fall 2016 Member of USF Tampa, Team 2-2, Blackwell Fall 2016

USFT-BLACKWELL-F16S2G2

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 103