Introduction

One of the most important features on the device is the fact they can upload pictures using the usb port. If yours isn't working that a problem and this guide is here to help. This guide also requires soldering for more on how to solder check the link here.

Using the black nylon spudger, pry off the clips all around the frame. You will hear a popping sound for every clip Be sure not to pry to hard because you could crack or break the plastic facing of the device. Be sure not to pry to hard because you could crack or break the plastic facing of the device.
  • Using the black nylon spudger, pry off the clips all around the frame. You will hear a popping sound for every clip

  • Be sure not to pry to hard because you could crack or break the plastic facing of the device.

Add Comment

Lift screen out of place so you can access the plugs that connect it.
  • Lift screen out of place so you can access the plugs that connect it.

Add Comment

Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up. Pull the ribbon cable away from the mother board.
  • Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.

  • Pull the ribbon cable away from the mother board.

  • Be careful as this zif connector is very frail plastic.

Add Comment

Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.
  • Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

Add Comment

Pull out remote receiver out of its clip.
  • Pull out remote receiver out of its clip.

  • Be careful to not move the wires around for the remote receiver too much, as they are soldered to the motherboard.

Add Comment

Using fingers pull the first speaker wire that is located closest to the speakers Again using your fingers, pull out the second speaker wire near the far side of the motherboard.
  • Using fingers pull the first speaker wire that is located closest to the speakers

  • Again using your fingers, pull out the second speaker wire near the far side of the motherboard.

Add Comment

Using the ph0 phillips head screwdriver  unscrew the four 4mm screws circled in the picture. Using the ph0 phillips head screwdriver  unscrew the four 4mm screws circled in the picture. Using the ph0 phillips head screwdriver  unscrew the four 4mm screws circled in the picture.
  • Using the ph0 phillips head screwdriver unscrew the four 4mm screws circled in the picture.

Add Comment

Pull up the smaller end of the motherboard.
  • Pull up the smaller end of the motherboard.

  • Apply force pulling away from the USB ports to get the mother board out of place.

Add Comment

On the back end of the mother board unsolder the USB port at the two points shown.
  • On the back end of the mother board unsolder the USB port at the two points shown.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Pascal Alexis

Member since: 11/05/2015

427 Reputation

3 Guides authored

Team

UMass Dartmouth, Team 5-1, Martin Fall 2016 Member of UMass Dartmouth, Team 5-1, Martin Fall 2016

UMASSD-MARTIN-F16S5G1

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 44