Fix Your Stuff Community Store

Altec Lansing BoomJacket Speaker Replacement

Introduction

Are your speakers not producing the same amount of BOOM that they used to? Perhaps repairing your speakers is the way to go.

What you need

  1. Altec Lansing BoomJacket Speaker Replacement, Speaker: step 1, image 1 of 1

    • Using your hands, remove the pegs (4+4) from the front and back of the speaker.

    Edit

  2. Altec Lansing BoomJacket Speaker Replacement: step 2, image 1 of 1

    • Remove the outer black rubber housing of the speaker.

    Edit

  3. Altec Lansing BoomJacket Speaker Replacement: step 3, image 1 of 1

    • Remove the inner blue rubber housing from the speaker.

    Edit

  5. Altec Lansing BoomJacket Speaker Replacement: step 4, image 1 of 1

    • Pull out the two black wire meshes using a metal spudger.

    • Be careful not to damage the metal casing.

    Edit

  6. Altec Lansing BoomJacket Speaker Replacement: step 5, image 1 of 2 Altec Lansing BoomJacket Speaker Replacement: step 5, image 2 of 2

    • Using tweezers remove the rubber stoppers (4 at the back + 2 at the front).

    Edit

  7. Altec Lansing BoomJacket Speaker Replacement: step 6, image 1 of 1

    • Using the size PH1 screwdriver remove the screws (4 around each speaker).

    Edit

  8. Altec Lansing BoomJacket Speaker Replacement: step 7, image 1 of 1

    • Pull the case apart and you will be able to see all the components inside the speaker.

    Edit

  9. Altec Lansing BoomJacket Speaker Replacement: step 8, image 1 of 1

    • Remove the speakers (not entirely because of the wiring) by gently pulling each speaker up.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 Comments

Where do I find the correct part to replace the charging port on my boom jacket?

Rockstar - Reply

1.1" External Magnetic Type Round Slim Plastic Shell Speaker 8 Ohm 0.25W 2 Pcs

Eeshton -

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 6

All Time: 740