Introduction

Use this guide to remove the head of an Afridev pump. Then follow the instructions in reverse order to install a replacement head.

Assemble the required tools, including the Afridev tool and crescent wrenches. Assemble the required tools, including the Afridev tool and crescent wrenches.
  • Assemble the required tools, including the Afridev tool and crescent wrenches.

Add Comment

Deck the Halls
With tools and Fix Kits
Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters. Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters. Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.
  • Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

Add Comment

Loosen the bolt on front of the face plate with the Afridev tool. Remove the plate from the pump by lifting it straight up.
  • Loosen the bolt on front of the face plate with the Afridev tool.

  • Remove the plate from the pump by lifting it straight up.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jake Devincenzi

Member since: 04/18/2011

101,342 Reputation

87 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 124