Introduction

Describes how to replace the HDD from the netbook.

Image 1/1:
  • Put the netbook, so the back side is upwards.

Add Comment

Image 1/1:
  • Push the right lock to the right so the red filed is visible on the left.

Add Comment

Image 1/1: When reassembeling the new battery push it up into the netbook and do lock the right by moving it to the left so the red field disappears.
  • Now move the left lock which is spring loaded to the leftand keep it there. Then with the other hand remove the battery by pulling down.

  • When reassembeling the new battery push it up into the netbook and do lock the right by moving it to the left so the red field disappears.

Add Comment

Image 1/2: Then move down along the sides where there is one pin on each side. After that twist the keyboard towards you. Image 2/2: Then move down along the sides where there is one pin on each side. After that twist the keyboard towards you.
  • Open the lid othe the netbook. Use the Jimmy from the upper left corner of the keyboard. Put it between the keyboard and th casing and move it to the right. It might help to use a metal spudger to push in the pins holding the keyboard in place.

  • Then move down along the sides where there is one pin on each side. After that twist the keyboard towards you.

Add Comment

Image 1/1:
  • Now open the brown connector so the flat cable is loose. Then you can remove the keyboard.

Add Comment

Image 1/1:
  • The hard disk drive is under the lighgrey casing and not screw to it.

Add Comment

Image 1/1:
  • Now push the HDD downwards with the finger through the hole.

Add Comment

Image 1/1: Now you can connect any Sata-HDD or SDD.
  • Remove the Sata connector from the hard disk drive.

  • Now you can connect any Sata-HDD or SDD.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Special thanks to these translators:

100%

These translators are helping us fix the world! Want to contribute?
Start translating ›

Claes

Member since: 02/01/2016

2,645 Reputation

12 Guides authored

Team

Master Techs Member of Master Techs

Community

263 Members

613 Guides authored

5 Comments

very helpful

many thanks

Pablo Tassinari - Reply

You are missing a few steps.

Arctic W. Fox - Reply

@Arctic W. Fox What steps are you missing?

Claes - Reply

The HD is removed through the back - there are about 5 screws (marked "Door") that need to be removed once the keyboard is removed. :-)

basestationzero - Reply

Thanks for the feedback, I added the steps at least in the German Guide do not know how long it takes for the steps to show up in the translated English Version.

Claes -

Add Comment

View Statistics:

Past 24 Hours: 15

Past 7 Days: 34

Past 30 Days: 108

All Time: 449