Introduction

At times, buttons can get stuck or quit working. When this happens, it may be necessary to replace the buttons.

Parts

No parts required.

Remove five 9.5 mm Phillips #1 screws from the back panel of the phone.
  • Remove five 9.5 mm Phillips #1 screws from the back panel of the phone.

Add Comment

Slide metal spudger into the crack around the Front Panel of the phone
  • Slide metal spudger into the crack around the Front Panel of the phone

  • Be careful not to break the clips holding the Back Panel to the Front Panel

Add Comment

  • When setting the back panel down, be careful to not rip any of the wires off of the internal components

Add Comment

  • Unscrew five 5.6 mm screws on top level, yellow motherboard.

Add Comment

  • Lift the top level Motherboard in order to get to the lower level Motherboard.

Add Comment

  • Unscrew the 5.6 mm screw on the clip behind the Screen as shown.

Add Comment

  • Unscrew five 5.6 mm screws on the lower level Motherboard.

  • Keep the screws for the upper and lower level motherboard separated.

Add Comment

  • Lift the lower level Motherboard upward.

  • Remove the silicon pad above the buttons.

Add Comment

  • Push the Button Panel upward and pull it out.

  • Replace the entire Button Panel or a single defective button.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Charles Messmore

Member since: 02/15/2016

520 Reputation

5 Guides authored

Team

IUPUI, Team 1-1, Harley Spring 2016 Member of IUPUI, Team 1-1, Harley Spring 2016

IUPUI-HARLEY-S16S1G1

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 3

All Time: 168