Introduction

This guide will show you how to replace buttons on the NVG510 modem.

Image 1/1: Remove rubber stands from the left corner only
  • Flip the router over so the stickers are facing upward.

  • Remove rubber stands from the left corner only

Add Comment

Image 1/1:
  • Take out both screws using the bit driver and 2.0 flathead

Add Comment

Image 1/2: Take out the one screw located on the middle left of the board Image 2/2: It may take some force to open the case
  • The case should now be open and the board should be revealed

  • Take out the one screw located on the middle left of the board

  • It may take some force to open the case

Add Comment

Image 1/2: Lift up slowly to ensure there will be no damage to the board Image 2/2: Lift up slowly to ensure there will be no damage to the board
  • Lift the board out of the case

  • Lift up slowly to ensure there will be no damage to the board

Add Comment

Image 1/1:
  • Locate the buttons near the yellow ports, they are to the right of the ports.

Add Comment

Image 1/3: Heat up the silver points to melt them off to release the button from the board Image 2/3: Avoid contact with the board with the solder, only touch the silver points Image 3/3: Avoid contact with the board with the solder, only touch the silver points
  • Using a solder, locate the silver points

  • Heat up the silver points to melt them off to release the button from the board

  • Avoid contact with the board with the solder, only touch the silver points

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 85