Take tablet and rotate on its side, so that the two screws are facing upward. Use Phillips #00 Screwdriver to remove   two 1mm screws on the left side of the tablet.
  • Take tablet and rotate on its side, so that the two screws are facing upward.

  • Use Phillips #00 Screwdriver to remove two 1mm screws on the left side of the tablet.

Add Comment

Insert plastic prying tool and pry back case away from the device slowly moving the plastic prying tool along the device.
  • Insert plastic prying tool and pry back case away from the device slowly moving the plastic prying tool along the device.

  • Once loosened, use hands to help separate case from device.

Add Comment

Hold positive and negative wires as close as possible to the speaker. Use plastic prying tool and fingers to simultaneously lift speaker from cover.
  • Hold positive and negative wires as close as possible to the speaker.

  • Use plastic prying tool and fingers to simultaneously lift speaker from cover.

  • Set cover aside.

Add Comment

Use soldering gun to remove the positive and negative wires connecting the battery to the circuit board.
  • Use soldering gun to remove the positive and negative wires connecting the battery to the circuit board.

  • For a complete guide on how to solder, click here.

Add Comment

Grip the ribbon located at the far end of the circuit board with a plastic spudger tool. Put pressure on the connector until the clasp comes undone.
  • Grip the ribbon located at the far end of the circuit board with a plastic spudger tool.

  • Put pressure on the connector until the clasp comes undone.

  • Gently pull up on electrical ribbon until it disconnects from circuit board.

Add Comment

Remove the second electrical ribbon from the motherboard. Use the technique for the previous ribbon.
  • Remove the second electrical ribbon from the motherboard.

  • Use the technique for the previous ribbon.

Add Comment

Using #00 Phillips Screwdriver, remove the four 1mm screws holding the circuit board to the device.
  • Using #00 Phillips Screwdriver, remove the four 1mm screws holding the circuit board to the device.

Add Comment

With fingers, grip the green Wi-Fi connector. Gently pull up on connector to remove tape holding the connector in place.
  • With fingers, grip the green Wi-Fi connector.

  • Gently pull up on connector to remove tape holding the connector in place.

Add Comment

Using your fingers, gently lift the motherboard.
  • Using your fingers, gently lift the motherboard.

Add Comment

Use soldering gun and when solder is malleable, lift up on the left side of the charge port until it is not connected to the board with tweezers.
  • Use soldering gun and when solder is malleable, lift up on the left side of the charge port until it is not connected to the board with tweezers.

  • Charging port may be very hot due to soldering iron.

  • Repeat this step on right side of charging port.

  • For a complete guide on how to solder, click here.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 18

All Time: 623