Image 1/2: '''Always''' take the '''negative''' terminal off first. Image 2/2: ''''''General Tip'''                                  After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job
  • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

Add Comment

Image 1/2: Loosen screw on metal band. Image 2/2: Loosen screw on metal band.
  • Unlatch the 2 clasps.

  • Loosen screw on metal band.

Add Comment

Image 1/2: Press on the 2 latches, pulling the cable away from sensor. Image 2/2: Press on the 2 latches, pulling the cable away from sensor.
  • Disconnect electronic sensor.

  • Press on the 2 latches, pulling the cable away from sensor.

Add Comment

Image 1/2: Remove MAFS. Image 2/2: Remove MAFS.
  • Disconnect hose from MAFS.

  • Remove MAFS.

Add Comment

Image 1/1: Spray MAFS cleaner along direction of travel, shown by arrow.
  • Steps 4-6 are for cleaning only.

  • Spray MAFS cleaner along direction of travel, shown by arrow.

Add Comment

Image 1/2: Image 2/2:
  • Clean electronic coupling with electronics cleaner.

Add Comment

Image 1/2: Image 2/2:
  • Inject conducting lubricant into MAFS electronic coupling.

Add Comment

Image 1/3: Tighten screw on metal band. Image 2/3: Latch clasps on either side of MAFS. Image 3/3: Latch clasps on either side of MAFS.
  • Re attach MAFS to air filter housing and intake hose.

  • Tighten screw on metal band.

  • Latch clasps on either side of MAFS.

Add Comment

Image 1/1:
  • Re attach electronic cable to MAFS.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Isaac Nitschke

Member since: 10/11/2010

61 Reputation

5 Guides authored

Team

Cal Poly, Team 3-28, Regan Fall 2010 Member of Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 7,662