Introduction

This procedure only requires 2 tools and the most difficult part will be pulling the case off with your hands without breaking it.

Image 1/1:
  • Push in the battery indicator.

Add Comment

Image 1/1: To put the battery back in, line up the battery's metal part with the camera's and slide it in.
  • Slide the battery out of the slot.

  • To put the battery back in, line up the battery's metal part with the camera's and slide it in.

Add Comment

Image 1/3: Use the Phillips #0 screwdriver to remove the two 5mm screws. Image 2/3: Use the Phillips #0 screwdriver to remove the three 5mm screws. Image 3/3: Use the Phillips #0 screwdriver to remove the three 5mm screws.
  • Use the Phillips #0 screwdriver to remove the two 5mm screws.

  • Use the Phillips #0 screwdriver to remove the two 5mm screws.

  • Use the Phillips #0 screwdriver to remove the three 5mm screws.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Use the plastic opening tool to loosen the plastic case of the camcorder.

Add Comment

Image 1/1: Gently pull on the case not to damage anything internally.
  • Use your hands to remove the plastic case.

  • Gently pull on the case not to damage anything internally.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Keven

Member since: 03/11/2016

601 Reputation

6 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 128