Last modified: 04/06/2021 12:05:02
Filter - Cabin (Remove and Replace)
Correction code 18100102
FRT 0.10
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com
Torque Specifications
Table 1. Torque Specifications: Filter - Cabin (Remove and Replace)
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|
Table Caption: Table Content 56209
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Screw that attaches the cabin filter cover to the HVAC module | Torque 1.2 Nm | 6mm socket Flex head ratchet/flex head torque wrench 4 in extension | Reuse |
Table Caption: This table provides specifications for a screw attaching a cabin filter cover to an HVAC module, including its torque value, recommended tools for installation, and whether the screw is reusable. It also includes a column for any additional notes regarding the procedure.
Remove
- Remove the RH side center console side panel carpet. See . Side Panel - Center Console - LH (Remove and Replace)
- Remove the screw that attaches the cabin filter cover to the HVAC module, and then remove the cover from the assembly.
Tip: Use of the following tool(s) is recommended:
-
6 mm socket
-
Flex head ratchet/flex head torque wrench
-
4 in extension
-
Fold the filter tabs outward, and then pull the upper filter out of the filter housing.
-
After the upper filter is removed, raise the lower filter up and out of the filter housing.
Install
-
Install the lower filter into the filter housing, with the arrows pointing to the rear of the vehicle.
-
Install the upper filter into the filter housing, with the arrows pointing to the rear of the vehicle, and then fold the filter tabs inward.
-
Install the cabin filter cover onto the HVAC module, and then install the screw that attaches the cabin filter cover to the HVAC module.
-
Torque 1.2 Nm
Note
Engage the lower cover tab before fastening the cover.
Tip: Use of the following tool(s) is recommended:
-
6 mm socket
-
Flex head ratchet/flex head torque wrench
-
4 in extension
-
Install the RH side center console side panel carpet. See . Side Panel - Center Console - LH (Remove and Replace)
