INSTALLATION INSTRUCTIONS

for the

Kodak X-Omat M43 and M43A

TRANSFORMER/CIRCUIT BREAKER KITS

for use with the

|

Kodak X-Omat M43, M43A, and Clinic 1 PROCESSORS

For 230 voit installation:

• [11] Connect the POWER CABLE from the main power supply.

2. (a) Insert the POWER CABLE into the TRANSFORMER BOX ASSEMBLY through the hole labelled SIN'.
3. (b) See Figure 1 on page 3. Connect the wires in the POWER CABLE to TB1 in the TRANSFORMER BOX ASSEMBLY:

• [12] Connect the INPUT CABLE from the PROCESSOR.

5. (a) Insert the INPUT CABLE into the TRANSFORMER BOX ASSEMBLY through the hole labelled 'OUT'.
6. (b) Connect the wires in the INPUT CABLE to TB2 in the TRANSFORMER BOX ASSEMBLY:

• [13] Tighten the NUTS on the 2 STRAIN RELIEFS.

Table Caption: This table outlines the connections for three different wires: L1, NEUTRAL, and a ground wire (or GND), specifying their respective connection points as TB1-1, TB1-2, and E1-1.

Table Caption: This table outlines the connections for three wires: L1, NEUTRAL, and a ground wire, specifying their corresponding terminal block connection points.

|

• [14] Check that the wires in the TRANSFORMER BOX ASSEMBLY are connected correctly. See Figure 3 on page 7.

H130_0029HCA

H130_0029HA

Figure 4 Electrical Supply Connections to the TB1 That Is in the PROCESSOR

Publication Change Notice Table

Table Caption: This table lists publication details including print date, publication number, ECO number, affected pages, and file names. It appears to document revisions or printings of specific documents.

1C0580

3229ii_k_087.txt

|

Kodak and X-Omat are trademarks.