Last modified: 24/06/2020 13:50:00

Closeout Panel - Door - Rear - LH (Remove and Replace)

Correction code 11701452

FRT 0.55

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.

NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com

Torque Specifications

Table 1. Torque Specifications: Closeout Panel - Door - Rear - LH (Remove and Replace)

Table Caption: Table Content 749282

Table Caption: This table outlines torque specifications, recommended tools, and reuse/replacement guidelines for various components of a window regulator and closeout panel assembly. It specifies precise torque values for bolts and screws, along with the necessary socket sizes and extensions for their installation.

Remove

• Remove the rear LH door glass. See . Glass - Door - LH - Rear (Remove and Replace)

• Release the connector lock, and then disconnect the LH rear window regulator motor connector.

• Remove the manual latch release cable from the window regulator panel.

• Disconnect the pressure sensor electrical connector, and then rotate the sensor counterclockwise to remove it from the closeout panel.

• Release the clips that attach the door harness to the closeout panel.

• Remove the bolts that attach the window regulator assembly to the door.

Torque 4 Nm

Tip: Use of the following tool(s) is recommended:

• 8 mm socket

• 2 in extension

• Remove the plugs that cover the regulator rail fasteners.

• Remove the bolts that attach the closeout panel assembly to the door, and then slide the assembly down and out to remove it from the door.

Torque 8 Nm

Tip: Use of the following tool(s) is recommended:

• 10 mm socket

• 6 in extension

• Remove the screws that attach the LH rear window motor to the closeout panel, and then remove the motor from the panel.

Torque 3.5 Nm

Tip: Use of the following tool(s) is recommended:

• Torx T25 socket
• 2 in extension
• Remove the screws that attach the rear window regulator to the closeout panel, and then release the window regulator mechanism from the closeout panel dowels.

Torque 3.5 Nm

Tip: Use of the following tool(s) is recommended:

• Torx T25 socket
• 2 in extension