Last modified: 11/10/2021 22:22:34
Cover - Shock Tower - LH (Remove and Replace)
Correction code 12251012
FRT 0.05
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com
Torque Specifications
Table 1. Torque Specifications: Cover - Shock Tower - LH (Remove and Replace)
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|
Table Caption: Table Content 892120
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolt that attaches the underhood storage unit to the washer fluid reservoir neck | Torque 5 Nm | 10mm socket Flex head ratchet/flex head torque wrench | Reuse |
Table Caption: This table provides specifications for a specific bolt, including its torque value, recommended tools for installation, whether it can be reused or needs replacing, and any additional notes.
Remove
- Open the LH front door and fully lower the LH front window.
- Remove the rear underhood apron. See . Underhood Apron - Rear (Remove and Replace)
- Remove the bolt that attaches the underhood storage unit to the washer fluid reservoir neck.
Torque 5 Nm
Tip: Use of the following tool(s) is recommended:
-
10 mm socket
-
Flex head ratchet/flex head torque wrench
-
Release the tabs that attach the washer hose to the washer tank neck, and then remove the washer tank neck from the vehicle.
-
Release the clip that attaches the harness to the LH shock tower cover.
-
Release the clips that attach the LH shock tower cover to the vehicle, and then remove the cover from the vehicle.
LH shock tower cover shown, RH similar
Install
Installation procedure is the reverse of removal.
