Section of the digitizer isn't working

Well my other problem is fixed but I have run into a new one. After replacing the digitizer a strip of the lower section of the digitizer doesn't respond. Is this a problem with the connection or the digitizer itself?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

Peter Hutchinson, it is my personal experience that whenever there is a particular spot on the digitizer, that does not work, it is a faulty digitizer. Of course, you always want to double and triple check your work. So make sure the cables are seated properly and that the connectors are in good working condition. If they are, you most likely will need a new digitizer. Hope this helps, good luck.

Was this answer helpful?

Score 2
Add a comment

Add your answer

Hutchpe will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 382