F&P Aquasmart, lid lock error, Board repair

My model WL70T60DW1 (no lcd), lid lock error.

fault desc: lid lock solenoid keeps clicking loudly until timeout.

Harness to solenoid measures 65 ohms. which is ok.

lid solenoid edge connector to fet measures 20 ohms.

Circuit description:

Board lid solenoid edge connector (marked +) tracks to 2 x 20 ohm surface mount resistors, in parallel, (located near pressure sensor),

then tracks to 2 x Drain pins of micro 8 pin dip fet package, (no numbers).

Repair desc: reflow solder on both 20 ohm resistors.

Verify: lid solenoid edge connector to fet now measures 10 ohms.

cheers.