Fix Your Stuff Community Store

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Questions View all

Options

iPhone 6 main speaker doesn't work after complete reassembly

Hello. I completly disassembled and assembled my iPhone 6, speaker was working normally, after assembly everything is working normally bud i don't get sound from the speaker. Volume doesn't say headphones so it is not stuck in that mode and i checked resistance on speaker and on the flex cable, both are the same, port looks fine under microscope, is there a possibility that a screw somewhere is different and that can be causing that problem? Thanks in advance

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest

Options

Hi

I suggest you clean the speaker contacts with isopropyl alcohol to speak away any dirt our human eyes can’t see

If this doesn’t work try holding the speaker contacts down to make sure it’s not a contact issue

Hopefully this helps

Any questions please ask

Thanks:-)

Was this answer helpful?

Yes No
Score 0

8 Comments:

Haven’t got one of the antenna wires caught under the speaker have you? Stupid question, mute switch on?

by

Thanks for your answer. I did both steps, but sadly it didn’t work. For a short while it was stuck in a headphone mode but when i tried to call and put it on loud speaker, no sound was played. Now im back when it says normal volume but still, doesn’t work.

by

@aricius

Try taking the logicboard out and assembling it without the screw and manually hold the speaker down to make sure there is proper contact :-)

by

@strongbow Hello, antenna wire is not stuck under the speaker, for testing i disconnected it completly and mute is off.

by

Show 3 more comments

Add a comment

Add your answer

Patrik Mesaroš will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 50