Two wires which run inside the unit are not connected any more, i took the back off and they have obviously broken off but from where? They are the red and black ones which are the only wires not in some sort of loom?
Is this a good question?
Rep: 449.6k
11
366
1.4k
Hi @dicky007 ,
Post some images of the board and the wires etc
Here’s how to do this. Adding images to an existing question
In most electronic devices the red and black coloured wires are used for the power supply. The convention is that the red goes to the +ve side of the supply and the black to the -ve side of the supply.
If the device has batteries check the wires that run from the +ve and -ve terminals in the battery holder. If they are OK look at the board and see if there are any markings indicating +ve and -ve where there might have been wires connected.
Was this answer helpful?
Past 24 Hours: 5
Past 7 Days: 7
Past 30 Days: 8
All Time: 116
