Aren't there supposed to be two wires connecting to the battery holder

I am trying to repair a Chantilly Singing Bear. The batteries were corroded inside the battery holder, so I cleaned it out with baking soda, but still it doesn't work. Opened it up and noticed on the red wire is attached to the battery holder, and there is a loose black wire just dangling from the circuit board not connected to anything. Isn't there supposed to be both a red and black wire connecting to it? Also, general tips on how to connect the wire back would be appreciated. I am very new to this.

Block Image

Block Image

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

2 Answers

Most Helpful Answer

@rblack connect the black wire (blue arrow) to the tab (red arrow) by soldering it. Use this guide to learn about soldering How To Solder and Desolder Connections

Was this answer helpful?

Score 2
Add a comment

yes the black wire should be connected

Was this answer helpful?

Score 0
Add a comment

Add your answer

RBlack will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 53