PWRSTION-10K-ALM MOPPS10KSLVV1 39.56Wh 10,000mAh Mophie PowerStation 5X

1 Questions View all

2 x 4.5 volt units, and 1 x 9 volt DC power block

As the title says, I have two 4.5 volt LED light strips (each one originally ran off 3x1.5 AA batteries). Can I use one 9 volt AC-to-DC power supply (wall wart type) to power these?

If so, do I wire these lights in series, or parallel?

Thanks!

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment
Black Friday
Broken doesn't stand a chance.

2 Answers

Chosen Solution

Keep your 9V AC adapter. Connect your LED strips in series. Use a resistor from your adapter to the LED strips.

You do need to know what LED's you have and how many. Typical values for LEDs are:

Red LED: 2V 15mA

Green LED: 2.1V 20mA

Blue LED: 3.2V 25mA

While LED: 3.2V 25mA

To figure out the size of the resistor use R = (V1 - V2) / I

R=(9-4.5)/I

(9-4.5)/0.02

4.5/0.02=225 ohms (easiest available resistor would b a 230ohm resistor)

Or you can use this calculatorto figure out how to wire it by using resistors.

Was this answer helpful?

Score 2

Comments:

the resistor values given are quite not right.in series connection , the current through one led passes through the rest of the leds.so the current stays constant.[inthis case 20mA.

by

@renre thank you and it has been corrected

by

Add a comment

Connection will be in series

Was this answer helpful?

Score 1

Comments:

Would you anticipate problems doing this? Would it be better to use TWO separate power supplies, 4.5 volts each?

by

No as long as you connect in the series no problems ..... resistance = V/Amps if you want can add a resistor , considering current 40ma for 2 led strips ....

by

Add a comment

Add your answer

Nicholas Kormanik will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 45

All Time: 45