Second generation of iPhone. Model A1241 / 8 or 16 GB capacity / black or white plastic back. Repair is more straightforward than the first iPhone. requires screwdrivers, prying, and suction tools.

1492 Questions View all

Replaced LCD no display!

There was dust between my LCD screen and Digitizer Screen so I took it apart and cleaned it. In the process Stupid me bend the LCD screen and broke it. I ordered a new LCD screen and replaced it following online instructions. Re attached the old back plate onto new screen and replugged the cables however there is no display what so ever! I thought maybe the phone was out of battery so I charged it in and PC recognized it. I then tried turning it on and again No display. SO I put in my broken LCD back in and still, no display...whats the issue??

Answered! View the answer I have this problem too

Is this a good question?

Score 0

Comments:

I was examining the new LCD panel and behind the ribbon close to the CHIP and LCD there is a slight tear very slight and the copper inside can be seen. It's not a complete tear, the black coating on the ribbon is peeled slightly. Could this be the issue? However, the old LCD won't work either and there i no tear on its ribbon.

by

Add a comment

1 Answer

Chosen Solution

Check and clean connector 1. Either that or you have blown another LCD/ ordered wrong part or been given bad lcd. Try hard reset... Press and hold home and power button for 10 seconds or try iTunes restore

Was this answer helpful?

Score 1

Comments:

I was examining the new LCD panel and behind the ribbon close to the CHIP and LCD there is a slight tear very slight and the copper inside can be seen. It's not a complete tear, the black coating on the ribbon is peeled slightly. Could this be the issue? However, the old LCD won't work either and there i no tear on its ribbon.

by

Any other ideas?

by

Add a comment

Add your answer

Tariq will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 1,756