Released on September 19, 2014, this 4.7" screen iPhone is the smaller version of the iPhone 6 Plus.

3054 Questions View all

I can't seem to unscrew them

iPhone 6 Front Panel Assembly Replacement

Step 10

None of the two screwdrivers that came with the fix kit seem to fit these screws.

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

2 Answers

Most Helpful Answer

The screws are single-use by Apple standards; they are easier to strip, and provide less torque feedback when trying to make them turn for the first time. For better results, they can be turned with a 2.0 flathead screw driver, or a 000 Phillips instead.

Was this answer helpful?

Score 1

Comments:

The kit has the 000 Phillips; it unscrewed the yellow-circled screw in the guide only, which is a 3.1 mm screw.

by

Add a comment

There should have been three screwdrivers in a replacement kit. The Phillip screwdriver will unscrew all the phillips heads in the iPhone. Maybe the angle at which you are trying to unscrew them from is incorrect. You need to position the screwdriver directly above the screw and not at an angle.

Was this answer helpful?

Score 1

Comments:

I tried that; I guess the required screwdriver is missing then.

by

Take a picture of the screw you are struggling to unscrew and the screwdriver you are using so I can confirm it for you? If this is the case you can get a new set for next to nothing on eBay.

by

Add a comment

Add your answer

Hadi Alkhamees will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 77