Updated version of the original iPad 2, released in March of 2012 with a smaller die processor and updated internal construction. Repair will require the use of heat and careful prying.

107 Questions View all

power, volume and lock buttons not working after cable replacement

I broke the old cable while removing the digitizer. I ordered a new one and followed the guide to remove and replace. Now none of the buttons on the cable work. I have seated the cable into it's socket on the camera board as appropriate (I think), and the cameras still work. Any suggestions on what I should try?

Answer this question I have this problem too

Is this a good question?

Score 2
Add a comment

1 Answer

Re-install the new cable, closely following the online instructions. Make sure all screws and connection ports are secure.

Was this answer helpful?

Score 0
Add a comment

Add your answer

accounts will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 134