Black and Decker CM0700BZ Water Piping Replacement

Introduction

The water pipes may become clogged, dirtied, or damaged to the point where they have to be removed and cleaned, or replaced entirely. This guide will show the steps to the disassembly process.

What you need

Step 1 Lid

Black and Decker CM0700BZ Water Piping Replacement, Lid: step 1, image 1 of 2

Black and Decker CM0700BZ Water Piping Replacement, Lid: step 1, image 2 of 2

Open the lid of the coffee maker.
Remove the brew cup.

Edit

Step 2

Black and Decker CM0700BZ Water Piping Replacement: step 2, image 3 of 3

Place your finger, screwdriver, or spudger behind the corner of the tab.
Pull up on the tab until it disconnects from the coffee maker.

Edit

Step 3

Black and Decker CM0700BZ Water Piping Replacement: step 3, image 3 of 3

Hold the tab while pushing back on the lid.
The lid should open fully with the top of the lid facing down.

Edit

Step 4

Insert the flathead screwdriver or spudger into one of the inserts holding the lid.
Pry facing away from the lid to force the peg out.
You should hear a pop when it disconnects.
Hold the lid and pull it away from the other insert.

Edit

Step 5

To also remove the shower head, use the Shower Head guide.

Edit

Step 6 Water Pipes

Black and Decker CM0700BZ Water Piping Replacement, Water Pipes: step 6, image 1 of 2

Black and Decker CM0700BZ Water Piping Replacement, Water Pipes: step 6, image 2 of 2

Remove the carafe holder from the bottom of the coffee machine.

Edit

Step 7

Black and Decker CM0700BZ Water Piping Replacement: step 7, image 3 of 3

Place coffee maker on its side, with the bottom facing you.
Remove two 10mm Phillips #1 screws and one 10mm Tri-Point Y1 screws with their designated tips.

Edit

Step 8

Black and Decker CM0700BZ Water Piping Replacement: step 8, image 3 of 3

Slowly pry bottom lid from the front.
You should hear a pop.
Pull up and remove the bottom lid and set aside.

Edit

Step 9

Follow Step #4 of the Power Button guide, but leave the button in the machine.

Edit

Step 10

Black and Decker CM0700BZ Water Piping Replacement: step 10, image 3 of 3

Remove the four 10mm Phillips #1 screws.
Slowly pull the water tank up to expose the water pipes.

Edit

Step 11

Black and Decker CM0700BZ Water Piping Replacement: step 11, image 3 of 3

Tool used on this step:

Tweezers

$4.99

Buy

Squeeze on the prongs with tweezers and hold.
Pull the water tank while squeezing the tighteners to loosen the water pipes off of the water tank.
The heating element should now be loose. Remove the heating element from the machine.