The port has been like this since I purchased it, but the pins were fine for about a couple of months before one pin bent, so I bent it back. Now it’s to the point where it won’t charge anymore.
Is this a good question?
Rep: 2.7k
6
3
2
really for bent pins in a charger its either you carefully try to bend the pins back into position
or
replace the connector.
these are pretty decently documented so you should be able to scrounge a new connector. but there isnt much else that can be done.
good luck!
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 3
Past 30 Days: 8
All Time: 54
