Rep: 53
3
1
I soldered the ribbon cable down to the logic board by the volume buttons, but I am a bit confused as to how I connect the upper part of the ribbon cable (The part that is for the lock button). Is there soldering involved, can someone please help me? Thank you!
Is this a good question?
Rep: 943
4
2
1
Hey Federico,
There is no soldering involved. There are two screws on the top holding power/lock button bracket in place. What I usually do is to first put the whole cable in place. So first screw in the lock button after screw in the volume button and than at the end I solder it to the board.
Hop that makes sense.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 428
