Nikon COOLPIX S610c Troubleshooting

Monitor is blank ¶ 

Camera is off ¶ 

Press the on/off button on top of the camera to turn it on.

Battery is exhausted ¶ 

Use the multi-connector port (labeled AV out) to charge the camera.

Battery is bad ¶ 

Nikon indicates the battery should last for around 290 shots per charge. If your camera is loosing battery charge much faster, it is likely your battery is bad. Follow the replace battery guide to fix this problem.

*Battery installation guide

Bad motherboard ¶ 

Follow the replace motherboard guide.

*Motherboard installation guide

Broken LCD screen ¶ 

Follow the replace LCD screen guide.

*LCD installation guide

Standby mode for saving power ¶ 

If the camera is in Standby mode, press the shutter-release button halfway.

Camera and computer are connected via USB cable ¶ 

The camera screen will be disabled when connected to the computer and must be unplugged before it can be used.

Camera and TV are connected via audio/video cable ¶ 

The camera screen will be disabled when connected to the TV and must be unplugged before it can be used.

Camera Turns Off Without Warning ¶ 

Battery is low ¶ 

Charge the battery by connecting the charging cord to the multi-connector port labeled "AV out" on the side of the camera.

Battery is bad ¶ 

Nikon indicates the battery should last for around 290 shots per charge. If your camera is loosing battery charge much faster, it is likely your battery is bad. Follow the replace battery guide to fix this problem.

*Battery installation guide

Camera has turned off automatically to save power ¶ 

The camera will turn off automatically if not used for a long period of time. Press the on/off button to turn it back on.

Battery is cold ¶ 

On cold days the battery loses a great amount of charge, and when the temperature goes below 32 degrees Fahrenheit it will not charge.

Camera Won't Take Pictures ¶ 

Battery is dead ¶ 

Charge the battery and try again.

Battery is bad ¶ 

Replace the battery

*Battery Installation Guide

Lens Assembly is Faulty ¶ 

Replace the lens assembly

*Lens Assembly Installation Guide

Date and Time on Display Are Incorrect ¶ 

When the date and time are not set, the words "Date not set" will blink during shooting.

All Settings Have Been Reset ¶ 

If both the battery and the backup battery have been depleted, then the settings will all return to their factory defaults. Your preferred settings will have to be entered manually.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 7

All Time: 805