Answer to: Error code on dryer F01My wife had the F01 code and found this thread for me. I pulled the top of our dryer, unplugged and removed the board and it's case. Then removed the board and YES we had the burn solder point. I used 18 gage silver stranded wire. As said above, the key is too keep from getting the board too hot. I curled the stranded wire so it hooked the points on both end and then dropped solder down on each point and then gently heated the solder on the point in place to make a good connection. By the way, we have an HE5 gas dryer, same board. THANKS!!!!