Answer to: Samsung Tab 3 SM-T210 LCD removal and replacementIve just done a Galaxy Tab 3 digitizer & LCD replacement. I used a hot water bottle 1/3 filled with fresh boiling water. The reason for it only being 1/3 filled was - if you put too much water in the hot water bottle it almost turns in to an oval shape. So you have less of the bottle touching the surface of the screen. With 1/3 the surface of the bottle remains quite flat, so all of the areas of the screen become heated, softening the glue enough to get a scalpel or other thin sharp object in. Once the digitizer was off it was just a matter of making sure all the peripherals & ribbon cables were disconnected from the logic board. Then place the exposed lcd side of the frame back on to a refilled 1/3 full hot water bottle. I found a small amount of adhesive holding the LCD to the inner frame. Once warmed up enough i then gently pressed the lcd from the inside part of the frame until the complete LCD just popped out. Installing the LCD & Digitizer was the same but in reverse. Once i was sure all the glass & oth...
Answer to: Is it possible to make a different Ver Screen work?To add one more point - Always try to get a genuine OEM digitizer. Because there have been quite a few instances where a non genuine digitizer is rendered completely useless after a software update. :-)