end of lvds broke wiresI have broken screen kids dropped it i removed plug from the screen and have other screens from ibook g4 g3 that the end matc...
Answer to: Battery not charging or seen by OSi change the ac plug on mine and worked fine its an easy swap out and should work also is battery the same if its off by a couple of numbers download the battery driver for that model and instal should see it then ifsays not compatable go into driver and take chckcmptbl out of driver also remove memory hold power button down 40 sec put battery in power up with the battery that wont charge in it should see it then
Answer to: Can't eject dvd tried all ways of ejecting, none workyou dont have to use pliers theres a tiny hole that releases it on the side use a needle and it will be free when powered down a thin piece of plastic and some two sided tape slide it out popsicle stick too thick give it a try theres some real thin two sided tape staples on sale spring might have got loose or you might have jamed two disk in on accident or lever over shot its stop point and now in limbo so use a disk on a stick should here the lever go back in place when done
Answer to: Damaged Display Data (LVDS) Connector - What to do now?You can get to the lvds cable easy enough just make sure you remove all the screws on the sides and back panel comes off unfotuanatly i have 6 cables from other macs that dont match one end or other. To get the screen outta loop you have to take battery out and remove the memory sticks, hold the power button down for 30 to 45 seconds put sticks back in and should work unless the new screen pin configuration is one wire off if you look at board and where the plug goes in should line up if it doesnt then you have wrong plug.too explain best theres twenty wires but only half are actually touching 3wires then space 2wires space 4wires you get the point on the board the wires should line up with board where it plugs in there should be the same configeration to plug if not it confuses the grafics and keeps cycling sorry for spelling but hope it helps