Skip to main content

Tools Featured in this Teardown

Introduction

This guide will walk you through the steps to completely disassemble a Sprint Airave.

This teardown is not a repair guide. To repair your Sprint Airave SCS-26UC2, use our service manual.

  1. Remove the external antenna, GPS cover, and GPS module. Remove the external antenna, GPS cover, and GPS module. Remove the external antenna, GPS cover, and GPS module.
    • Remove the external antenna, GPS cover, and GPS module.

  2. Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off. Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off. Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off.
    • Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off.

  3. Locate and remove the four Phillips screws
    • Locate and remove the four Phillips screws

  4. MacBook Battery Fix Kits

    Starting at $69.99

    Buy Now

    MacBook Battery Fix Kits

    Starting at $69.99

    Buy Now
  5. With the cover removed you now have access to the circuit board.
    • With the cover removed you now have access to the circuit board.

  6. Using an 8mm socket you can remove the antenna pigtail.
    • Using an 8mm socket you can remove the antenna pigtail.

  7. Release the clip indicate to remove the circuit board.
    • Release the clip indicate to remove the circuit board.

  8. Here is the circuit board fully removed. Here is the circuit board fully removed.
    • Here is the circuit board fully removed.

Erik Leonard

Member since: 06/11/2011

164 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 3,112