Introduction

I'm going to open my old Nokia phone to have a look.But I only have very limited English writing skills and I hope you'll understand what I'm talking about.

This teardown is not a repair guide. To repair your Nokia 6108, use our service manual.

  1. Hello,I'm going to open my phone for some fun.
    • Hello,I'm going to open my phone for some fun.

      • Be careful not to drop any screws or parts when you're opening your phone.This may render your phone not usuable.Open your phone at your own risk.

  2. Remove the following parts.
    • Remove the following parts.

      • Battery cover

      • Battery

      • SIM card

    • Remove two trox screws marked in figure 2.

    • Remove the front panel by pulling it or using an

      • I don't have a opening tool.So I used a flathead screw driver instead.

    • Be careful not the damage the number pad connector(highlighted in red).If you break it.You'll have to replace the entre front panel.

    • Remove 5 trox screws that are holding the screen and the touch pad.

    • After removing the touch pad and the screen.You can remove the logic board from the case.

    • The board seem don't want to leave its cozy home.

    • Let's start removing the parts under the logic board.

    • Parts need to be removed.

      • A motor

      • Charger connector

      • A speaker

    • Removing the EMI shield.Pry around the edge of the shield to remove it.

    • Nothing under the EMI shield.

    • I think we should stop here right now.There are pictures for all parts.

Honam1021

Member since: 02/19/2011

322 Reputation

1 Guide authored

One Comment

i have same phone but it's keypad button's are not working.... can u help me that

Rohit Yadav - Reply

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 4,325