iPad 2nd and 3rd Gen Home Button Control Board

$14.95

Product code: IF110-008
Apple Part #: 820-2943-A

Click Image To Zoom

 
 

iPad 2nd and 3rd Gen Home Button Control Board

$14.95

Product code: IF110-008
Apple Part #: 820-2943-A

Product Overview

This part does not contain the plastic home button or the metal mounting bracket which is adhered to the front panel. You can buy the full home button assembly as well:

Home Button Assembly

Compatibility

Identify your iPad

  • All Second Generation iPads
  • All Third Generation iPads

Product Details

$14.95 New

 
 

Condition:

New

Warranty:

One year warranty

$9.95 A-Stock

 
 
 

Condition:

Used, fully tested

Warranty:

One year warranty

Add to Cart
 

Replacement Guides

iPad 2 CDMA

Difficulty: Very difficult

iPad 2 GSM

Difficulty: Very difficult

iPad 2 Wi-Fi EMC 2415

Difficulty: Very difficult

iPad 2 Wi-Fi EMC 2560

Difficulty: Very difficult

iPad 3 4G

Difficulty: Very difficult

iPad 3 Wi-Fi

Difficulty: Moderate

 

Compatibility

iPad 2 CDMA
16 GB
32 GB
64 GB
iPad 2 GSM
16 GB
32 GB
64 GB
iPad 2 Wi-Fi EMC 2415
16 GB (EMC 2415)
32 GB
64 GB
iPad 2 Wi-Fi EMC 2560
16 GB (EMC 2560)
iPad 3 4G
16 GB LTE/CDMA (3rd Gen)
16 GB LTE/GSM (3rd Gen)
32 GB LTE/CDMA (3rd Gen)
32 GB LTE/GSM (3rd Gen)
64 GB LTE/CDMA (3rd Gen)
64 GB LTE/GSM (3rd Gen)
iPad 3 Wi-Fi
16 GB Wi-Fi (3rd Gen)
32 GB Wi-Fi (3rd Gen)
64 GB Wi-Fi (3rd Gen)
 

Stories

My Problem

Pushing the home button had no results unless it was pushed very hard

My Fix

The new parts ordered were installed without concern. After cleaning off the glue strips, I temporarily installed the digitizer screen and the home button still did not function as expected. Made some measurements and found that the two pins that are on the charge assy were not contacting the home button control board. The two angled screws from the charge harness were removed. A piece of black tape was used under the charge harness to lift it slightly higher. Parts were reinstalled and it then functioned as expected.

My Advice

Make sure to totally clean off all old glue strips. Also clean off old glue residue the best you can. This good prep will insure good bonding of the digitizer screen to the ipad housing. Also make sure all smudges are cleaned off the LCD screen and inner digitizer screen before final installation. Good luck.. This procedure is very easy if you just take your time.