Click Image To Zoom
California Prop 65
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Learn more >
Tech Specs ¶
Lens Diameter: 30 mm
Lighting: White LED
Power: 2 C Cell Included
April 8, 2014
After very successfully replacing my 2005 HP iPod Photo battery with an iFixit kit, I just picked up a few items that will help on some of the miniature work that I'm into right now.
My eyes aren't getting any younger so the Head Magnifier, Helping Hands and Inspection scope will keep the details in sight.
The two Gerstner Toolboxes are going to free up some bench space and keep the small stuff organized.
The Flush Wire Cutter is the best there is and will make quick work out of small places.
The images show my 38" diameter digital clock that uses Atomic Clock reference reception of WWVB.
My lighted hands digital clock will need everything from my tool order and more.
The clock uses two Microchip 8-bit controllers - One to advance the current Atomic Time, set time zone and adjust lamp brightness while positioning the two proportional servos to the correct hand positions. This chip also outputs a pulse-train of current time into a second controller chip that acts as a smart port expander that drives the twelve purple hour LEDs which pattern against the current time from a table of time & actions in its memory.
Some of my tools date back to the late 70's so a tool upgrade was sorely needed.
As modern devices get smaller and smaller, the right tools are just what the doctor ordered.
February 3, 2014
Left fan started making terrible noise
Piece of cake
The instructions would have benefited with some close up photos of the fan power connector. Both seated and unseated, so you could see how it snapped together.
June 19, 2013
First it looked like it was a tweak problem.
After installing a audio tweak only the up button was responding.
but after de installing and checking on the internet it seems clear that the audio control button itself was broke.
The button was also not making the same sound as the up button when you press it, also pressing feels different.
So I searched the net and found FIXIT.
First there was some misunderstandin
Pretty easy, just follow the manual...Nice set up
As electronic developer/insta
What could be on option, and that is what I always do when I have to demount a lot of screws: I just print a A3 or A4 paper with square blocks and numbers. when I take out some screws I put this in step one. the next screws I place between the lines at step two etc.
Or what I did in this case, I just printed out the pictures in small format and placed the screws on the top of the drawing where I took them out.
Very easy, you never put the wrong screw on the wrong location.