Click Image To Zoom
California Prop 65
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Learn more >
|iPad 3 4G||
|iPad 3 Wi-Fi||
Unable to turn off the the screen and dock connector was mangled.
Followed the guides and things went ok, but I damaged the wifi antenna opening it... and the cable to the digitalizer pulled loose (left side of screen went dead) when I laid the glass flat next to it. So ordered both of those and finished up in about 20 minutes.
When opening separate the wifi antenna from the glue on the digitalizer or you will replace it. Set a cup or something next to it and lean the digitalizer standing up at 90 degrees verse laying flat... no stress on it that way.
I bought an iPad3 from eBay for $130 with it unable to charge. So I looked up how to repair an iPad that is not able to be charged on iFixit. I saw that it looked like a strait forward repair. If I could fix this iPad it would be a way for me to have an iPad with a retina display for a very reasonable price.
When I received my iPad I noticed that there was a large scratch on the glass face so I ordered a new digitizer along with the charging dock connector.
Removing the digitizer was fairly simple. With careful application of heat along the edges of the digitizer I was able to lift the edges paying close attention to the areas mentioned in the instruction guide to avoid damaging the underlying components. R&Ring the docking connector was simple after determining that the screws holding it down were size 000 and not 00 as described in the guide. Everything went back together easily and the iPad started charging as soon as I plugged it in. Happy, happy, joy, joy!!!
I had trouble starting the plastic pry bar under the digitizer so I used an exacto knife blade to just push in between the glass and the bezel. As soon as the glass began to move I was able to insert the plastic pry bar under the glass and I never used the exacto knife again.
Using a heat gun really made lifting the glass easy and if I had to repair the iPad again this is what I would use. Going slowly and carefully is very important to keep from damaging any other components.
I didn't remove the display connector when I disconnected the digitizer connectors. Why remove the connector when I didn't have to. I carefully laid the display out of the way so I didn't stress the ribbon cable. Also, the digitizer cable doesn't pull straight up as noted in the guide but slides out of the connector to the left. Reinserting the digitizer cable into the connector is somewhat difficult because the ribbon cable is stiff and springy. Take your time and you will eventually get it slid into place.
I did get some finger prints on the display but was able to easily clean them off with a microfiber cloth by gently wiping.
Thank you iFixit for your excellent guides and fast delivery of repair parts. I have other work to do on iPhone's and laptops and I will be buying more parts from you guys. I'm very glad you're here!
The chargeing port was broken and I bought the part from you guys and I fixed it. It charges Now but I broke the touch screen now so looks like I'm buying a nother part from you guys now
It went well
Watch a YouTube video of fixing a iPad it would be so much easier If you do
IPAD 3 was dropped on the docking connector with the cable inserted - breaking the internal connector
Repair was easier than expected, the hardest part was opening the case, the rest of the fix is quite straight forward - I would not rate it as "very difficult"
the IFIXIT guide instructs you to disconnect the connectors for the touch sensor and LCD screen - really not necessary to do so - just flip the touch sensor and the LCD screen over (to the left) and out of the way and the docking connector can easily be changed without disconnecting anything but the docking connector itself